Carolina Colortones retail

James Hardie Artisan® Lap Siding Installation Guide

A plain-English summary of the manufacturer’s installation requirements, with links to the official documents.

Key Facts

  • Artisan is James Hardie’s thick-profile lap with a tongue-and-groove edge, in beaded, shiplap, V-groove and square-channel profiles.
  • Requires a 1½” starter strip and trim at least 1½” thick for correct shadow lines.
  • Butt joints do not need to land on a stud; do not nail within 2″ of the tongue and groove at plank ends.
  • Cut the tongue or groove off where a plank butts into trim.
  • Carry every plank on edge, never flat — one person holds the middle with arms spread, two people hold near each end.
  • Cut only with a HardieBlade saw and HEPA extraction (score-and-snap is not listed for Artisan). Never indoors.
  • Studs at 24″ o.c. maximum, foam sheathing up to 1″, water-resistive barrier required, vertical walls only.

What Artisan is

Artisan is the premium, thicker fiber cement lap from James Hardie. Its heavier profile throws a deeper shadow line than standard HardiePlank and its tongue-and-groove edge creates a tight, interlocking joint. It is specified where the budget allows a true milled-wood look in fiber cement.

Installation summary

Storage flat and dry; edge-carry only. Framing at 24″ o.c.; irregular framing shows through. Water-resistive barrier and flashing per code; grade sloped 6″ in 10′. Install the 1½” starter strip, then set planks with the tongue engaged in the groove of the course below, leaving the specified gap at trim and caulking it. Follow the fastener schedule and clearance figures in the PDF. Finish with paint, never stain.

What Carolina Colortones does with Artisan

Artisan’s smooth face is where factory finishing shows its value: an even, correct-mil-thickness coating with no brush marks, applied to faces and edges before the tongue-and-groove is engaged, so there is no unfinished line if a joint moves.

Artisan pre-finished in your color

Free samples ship anywhere in the continental United States. Every order is finished in our climate-controlled Western North Carolina facility.

Frequently Asked Questions

1½” minimum, so the siding does not stand proud of the trim.

The Artisan document lists only saw cutting with a HardieBlade and HEPA extraction.